[May 22, 2024] Ultimate 350-801 Guide to Prepare Free Latest Cisco Practice Tests Dumps
Get Top-Rated Cisco 350-801 Exam Dumps Now
NEW QUESTION # 100
Which two protocols should be configured for the cisco unity connection and cisco UCM integration?
- A. SIP
- B. H.323
- C. MGCP
- D. SCCP
- E. RTP
Answer: A,D
NEW QUESTION # 101
Endpoint A is attempting to call endpoint B.
Endpoint A only supports G.711ulaw with a packetization rate of 20 ms, and endpoint B supports packetization rate of 30 ms for G.711ulaw. Which two media are resources are allocated to normalize packetization rates through transrating?
- A. Software transcoder on Cisco unified Communications manager
- B. Software MTP on Cisco Unified Communication Manager
- C. Hardware transcoder on Cisco IOS Software
- D. Hardware MTP on Cisco IOS Software
- E. Software MTP on Cisco IOS Software
Answer: B,D
NEW QUESTION # 102
A Cisco Telepresence SX80 suddenly has issues displaying main video to a display over HDMI.
Which command can you use from the SX80 admin CLI to check the video output status to the monitor?
- A. xcommand video status
- B. xconfiguration video Output
- C. xStatus HDMI Output
- D. xStatus video Output
Answer: D
NEW QUESTION # 103
Which Cisco Unified Communications Manager feature is to determine the maximum bit rate for a call between two video-endpoints?
- A. Locations
- B. Regions
- C. transformations
- D. Partitions
Answer: B
NEW QUESTION # 104
Which configuration tells a switch port to send Cisco Discovery protocol packets that configure an attached Cisco IP phone to trust tagged traffic that is received from a device that is connected to the access port on the Cisco IP phone?
A)
B)
C)
D)
- A. Option D
- B. Option C
- C. Option A
- D. Option B
Answer: D
NEW QUESTION # 105
Endpoint A is attempting to call endpoint B.
Endpoint A only supports G.711 ulaw with a packetization rate of 20 ms, and endpoint B supports packetization rate of 30 ms for G.711ulaw.
Which two media are resources are allocated to normalize packetization rates through transrating?
- A. Software transcoder on Cisco unified Communications manager
- B. Hardware MTP on Cisco IOS Software
- C. Software MTP on Cisco Unified Communication Manager
- D. Software MTP on Cisco IOS Software
- E. Hardware transcoder on Cisco IOS Software
Answer: B,E
Explanation:
Software MTP - Software-only implementation that does not use a DSP resource for endpoints using the same codec and the same packetization time.
Hardware MTP - Hardware-only implementation that uses a DSP resource for endpoints using the same G.711 codec but a different packetization time. The repacketization requires a DSP resource so it cannot be done by software only. Cisco Unified Communications Manager also uses the term software MTP when referring to a hardware MTP.
https://www.cisco.com/c/en/us/td/docs/routers/access/vgd1t3/rel1_0/software/configuration/guide/VGD_transcoding.html
NEW QUESTION # 106
Refer to the exhibit.
Refer to the exhibit. A customer submits this debug output, captured on a Cisco IOS router. Assuming that an MGCP gateway is configured with an ISDN BRI interface, which BRI changes resolve the issue?
- A.
- B.
- C.
- D.
Answer: C
NEW QUESTION # 107
A DTMF mismatch is occurring between an MGCP gateway registered FXS port and a Cisco Unified communications Manager SIP trunk. Which media resource can be leveraged to interwork this mismatch?
- A. Conference Bridge
- B. Trusted relay point
- C. Media Termination point
- D. Annunciator
Answer: C
NEW QUESTION # 108
An engineer is configuring a BOT device for a Jabber user in Cisco Unified Communication Manager Which phone type must be selected?
- A. third-party SIP device
- B. Cisco Dual Mode for Android
- C. Cisco Dual Mode for iPhone
- D. Cisco Unified Client Services Framework
Answer: B
Explanation:
Section: Collaboration Applications
Explanation/Reference: https://www.cisco.com/c/en/us/td/docs/voice_ip_comm/jabber/11_5/ CJAB_BK_D00D8CBD_00_deployment-installation-guide-cisco-jabber115/ CJAB_BK_D00D8CBD_00_deployment-installation-guide-cisco-jabber115_chapter_01000.html
NEW QUESTION # 109
What are two functions of Cisco Expressway in the Collaboration Edge? (Choose two.)
- A. The Expressway-C and Expressway-E pair can enable connectivity from the corporate network to the PSTN via a T1/E1 trunk.
- B. The Expressway-C and Expressway-E pair can interconnect H.323-to-SIP calls for voice.
- C. Expressway-C provides encryption (or Mobile and Remote Access but not (or business-to-business communications.
- D. Expressway-E provides a perimeter network that separates the enterprise network from the Internet.
- E. Expressway-E provides a VPN entry point for Cisco IP phones with a Cisco AnyConnect client using authentication based on certificates.
Answer: B,C
NEW QUESTION # 110 
Refer to the exhibit. An engineer is troubleshooting a codec negotiation issue where both endpoints that are involved in the call support the codecs listed in the exhibit. Which audio codec is selected if a call between two endpoints in Region1 is placed?
- A. G.711a
- B. G.729
- C. G.711u
- D. G.722
Answer: D
Explanation:
Section: Protocols, Codecs, and Endpoints
Explanation
NEW QUESTION # 111
Refer to the exhibit.
Refer to the exhibit. An administrator accesses the terminal of a Cisco UCM and starts a packet capture. Which two commands must the administrator use on Cisco UCM to generate DNS traffic? (Choose two.)
- A. show cdp neighbor
- B. utils ntp status
- C. autils diagnose module validate Network
- D. utils diagnose test
- E. show version active
Answer: C,D
NEW QUESTION # 112
Which two steps are required for bulk configuration transactions on the Cisco UCM database utilizing BAT? (Choose two)
- A. A data file in Extensible Markup Language format must be uploaded to Cisco UCM
- B. A data file in Abstract Syntax Notation One format must be uploaded to Cisco UCM
- C. A data file in comma-separated values format must be uploaded to Cisco UCM
- D. A device template must be created in Cisco UCM.
- E. A server template must be created in Cisco UCM.
Answer: A,C
NEW QUESTION # 113
A collaboration engineer must configure Cisco Unified Border Element to support up to five concurrent outbound calls across an Ethernet link with a bandwidth of 160 kb to the Internet Telephony Service Provider.
Which set of commands allows the engineer to complete the task without compromising voice quality?
- A. dial-peer voice 1 voip
translation-profile outgoing Strip9
max-conn 5
destination-pattern 91[2-9]..[2-9]......$
session protocol sipv2
session target ipv4:142.45.10.1
dtmf-relay rtp-nte sip-notify sip-kpml
codec ilbc mode 20 - B. dial-peer voice 1 voip
translation-profile outgoing Strip9
max-conn 5
destination-pattern 91[2-9]..[2-9]......$
session protocol sipv2
session target ipv4:142.45.10.1
dtmf-relay rtp-nte sip-notify sip-kpml
codec aacld - C. dial-peer voice 1 voip
translation-profile outgoing Strip9
max-conn 5
destination-pattern 91[2-9]..[2-9]......$
session protocol sipv2
session target ipv4:142.45.10.1
dtmf-relay rtp-nte sip-notify sip-kpml
codec mp4a-latm - D. dial-peer voice 1 voip
translation-profile outgoing Strip9
max-conn 5
destination-pattern 91[2-9]..[2-9]......$
session protocol sipv2
session target ipv4:142.45.10.1
dtmf-relay rtp-nte sip-notify sip-kpml
Answer: A
Explanation:
Explanation/Reference:
NEW QUESTION # 114
Which command in the MGCP gateway configuration defines the secondary Cisco Unified Communications Manager server?
- A. Mgcp call-agent
- B. ccm-manager fallback-mgcp
- C. Mgcpapp
- D. ccm-manager redundant-host
Answer: D
Explanation:
https://www.cisco.com/c/en/us/td/docs/routers/access/vgd1t3/rel1_0/software/configuration/guide/ VGD_mgcp.html ccm-manager fallback-mgcp - Enables the MGCP fallback feature ccm-manager redundant-host {ip-address | DNS-name} [ip-address | DNS-name] - Identifies up to two backup Cisco Unified Communications Manager servers.
upvoted 2 times
NEW QUESTION # 115
A Cisco collaboration engineer is troubleshooting unexpected SIP call disconnect. Which three responses corresponding to the 5xx range? (Choose Three)
- A. Unauthorized
- B. Forbidden
- C. Request timeout
- D. Bad gateway
- E. Service unavailable
- F. Internal server error
Answer: D,E,F
NEW QUESTION # 116
Refer to the exhibit.
The SDP offer/answer has been completed successfully but there is no DTMF when users press keys. What is the cause of the issue?
- A. Payload type 110 was negotiated rather than type 101.
- B. DTMF was not negotiated on the call.
- C. G.729 rather than G.711ulaw was negotiated.
- D. DTMF was negotiated properly in these messages.
Answer: A
NEW QUESTION # 117
A collaboration engineer configures Global Dial Plan Replication for multiple Cisco UCM clusters.
The local cluster acts as the hub cluster and the remaining clusters act as spoke clusters.
Which service must the engineer configure on the local cluster?
- A. intra-Cluster Communication Signaling
- B. Mobility Cross Cluster
- C. Intercluster Lookup Service
- D. Location Conveyance on intercluster SIP trunks
Answer: C
NEW QUESTION # 118
Refer to the exhibit.
A call to an international number has failed. Which action corrects this problem?
- A. Add the isdn switch-type primart-dms100 command to the serial interface.
- B. Strip the leading 011 from the called party number
- C. Add the bearer-cap speech command to the voice port.
- D. Assign a transcoder to the MRGL of the gateway.
Answer: B
NEW QUESTION # 119
Which packet delay is the maximum supported between Cisco Unified Communications Manager nodes for clustering over WAN deployments?
- A. 510 ms round trip
- B. 40 ms round trip
- C. 150 ms round tip
- D. 80 ms round trip
Answer: D
Explanation:
Explanation/Reference: https://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cucm/srnd/collab11/collab11/callpros.html
NEW QUESTION # 120
......
Understanding functional and technical aspects of Implementing Cisco Collaboration Core Technologies (350-801 CLCOR) Call Control
The following will be discussed in CISCO 350-801 exam dumps:
- Configure and Troubleshoot Integrated Services Digital Network (ISDN) Primary Rate Interface (PRI)
- Configure Batch Provisioning
- Standard local route group
- Route patterns (traditional and +E.164 format)
- Describe Mobile and Remote Access (MRA)
- Configure IP Network Protocols
- Implement and Troubleshoot Digit Manipulation on a Cisco IOS Gateway
- Configure and Troubleshoot Collaboration Endpoints
- Implement toll fraud prevention on Cisco Unified CM
- Describe the Cisco Unified Communications Manager digit analysis process
- Using Certificates
- Examine Cisco IOS Gateway Inbound and Outbound Dial-Peer Functions
- Troubleshoot Calling Issues
- Configure globalized call routing in Cisco Unified CM
- Implement Endpoint Addressing and Call Routing
- Configure Self-Provisioning
- Deploy an IP Phone Through Auto and Manual Registration
- Translation patterns
- Explore the Cisco VoIP Bandwidth Calculator
Passing Key To Getting 350-801 Certified Exam Engine PDF: https://www.vcedumps.com/350-801-examcollection.html
350-801 Exam Dumps Pass with Updated Tests Dumps: https://drive.google.com/open?id=1TGRlfF93sp4jhq81Di4FDVSEnHYfucjg
